System Administration Commands wpad(1M)
NAME
wpad - WPA and WPA2 protocol daemon
SYNOPSIS
/usr/lib/inet/wpad [-i interface] [-k presharedkeyname]
DESCRIPTION
The wpad daemon provides common client functionality for the
WiFi Protected Access (WPA) versions 1 and 2, as defined by
IE802.11i standard. WPA was created by the WiFi Alliance,
an industry trade group. WPA implements the majority of the
IE 802.11i standard, and was intended as an intermediate
measure to take the place of Wired Equivalent Privacy (WEP)
while 802.11i was prepared. WPA2 implements the full stan-
dard.
wpad provides the following WPA/IE 802.11i features:
o WPA-PSK ("WPA-Personal")
o Key management for CMP, TKIP, WEP104, WEP40
Stop and start the wpad daemon using dladm(1M). Use:
# dladm connect-wifi
...to start the wpad daemon. Use:
# dladm disconnect-wifi
...to stop the daemon.
OPTIONS
The following options are supported:
-i interface
Specify a WiFi Link interface to start the wpad daemon.
-k presharedkeyname
Specify the pre-shared key used for the WiFi Link.
SunOS 5.11 Last change: 11 Mar 2008 1
System Administration Commands wpad(1M)
EXAMPLES
Example 1 Starting the wpad Daemon on Specific WiFi Link
To create the WPA key psk, enter the following command:
# dladm create-secobj -c wpa psk
To use key psk to connect to ESID wlan on link ath0, enter
the following command:
# dladm connect-wifi -k psk -e wlan ath0
Example 2 Stopping the wpad Daemon on Specific WiFi Link
To stop the daemon on the link ath0, enter:
# dladm disconnect-wifi ath0
ATRIBUTES
See attributes(5) for descriptions of the following attri-
butes:
ATRIBUTE TYPE ATRIBUTE VALUE
Availability SUNWwpau, SUNWwpar
Interface Stability Uncommitted
SEE ALSO
svcs(1), dladm(1M), svcadm(1M), attributes(5), smf(5)
NOTES
The wpad service is managed by the service management facil-
ity, smf(5), under the service identifier:
SunOS 5.11 Last change: 11 Mar 2008 2
System Administration Commands wpad(1M)
svc:/network/wpa:
Administrative actions on this service, such as enabling,
disabling, or requesting restart, can be performed using
svcadm(1M). The service's status can be queried using the
svcs(1) command.
SunOS 5.11 Last change: 11 Mar 2008 3